Sheet Metal
& Steel Fabrication

Services

CNC Bending & Folding

Home/Services

CNC bending turns flat profiles into three-dimensional parts — brackets, channels, trays and panels folded to precise, repeatable angles. The press brake is programmed from the same drawing as the laser, so holes land where they should after folding.

Accuracy in folding is about allowance and sequence. Every material and thickness has its own bend allowance, and every part has a correct fold order. Programmed bending removes both variables, which is why a run of 500 brackets folds the same on the first and the last part.

Scope of the work

  • Air bending — the standard for most sheet work
  • Brackets, channels & trays — folded to drawing
  • Multiple bends — sequenced to avoid tool and part collision
  • Long folds — to 3200mm bend length
  • Prototype folding — first-off checked before the run

Specifications

Bend lengthUp to 3200mm
Mild steelTo 10mm
StainlessTo 6mm
AluminiumTo 6mm
Tolerance±0.5° programmed

Typical jobs

  • Mounting brackets
  • Panel returns
  • Channels and rails
  • Trays and covers
  • Folded prototypes

The way we work it

We select tooling to suit the material and the inside radius, calculate the bend allowance for the actual thickness, and check the first-off against the drawing. Only then does the run continue.

Workshop checkpoint

The first folded part is measured against the drawing before the balance of the run. If the angle or the flange length is out, the program is corrected.

Common question

What inside radius should I allow?

A practical rule is the inside radius equals the material thickness. Tighter radii are possible but require specific tooling — tell us the mating part and we will advise.

Send us this

  • The finished dimensions — we can develop the flat pattern
  • Material and thickness, which determine the bend allowance
  • The inside radius or the mating part it must match
  • Any critical hole-to-edge distances to hold

Often ordered together

Asked on the phone

Why did my first sample come out over-bent?

Over-bending is usually springback — the metal relaxing slightly after the press releases. We compensate for springback in the program so the finished angle matches the drawing, not the press setting.

Ready to start a job?

Send a drawing and we will come back with pricing and a lead time.

Request a Quote