The CNC press brake folds flat profiles into precise three-dimensional parts. With a bend length to 3200mm, it handles everything from small brackets to full-length panels, with angles held to ±0.5° across the run.
Folding accuracy is about allowance and sequence. We calculate the bend allowance for the actual material and thickness, select tooling to suit the inside radius, and program the fold order so each bend lands where the drawing says it should.
What the brake covers
- Air bending — the standard for sheet work
- Brackets, channels and trays — folded to drawing
- Long folds — to 3200mm bend length
- Multiple bends — sequenced to avoid collision
- First-off checking — measured before the run
Specifications
| Bend length | Up to 3200mm |
| Mild steel | To 10mm |
| Stainless | To 6mm |
| Aluminium | To 6mm |
| Tolerance | ±0.5° programmed |
Typical parts
- Mounting brackets
- Panel returns
- Channels and rails
- Trays and covers
- Prototype folds
How we fold
Tooling is selected for the material and inside radius, the allowance is calculated for the actual thickness, and the first-off is measured before the run. If the angle or flange is out, the program is corrected.
First-off measured
The first folded part of every run is measured against the drawing. The program is adjusted until it is right, then locked for the balance.
Common question
What inside radius should I allow?
As a rule, the inside radius equals the material thickness. Tighter radii are possible with specific tooling — tell us the mating part and we will advise.
Set-up and changeover
Each new job starts with tool selection and a first-off bend. The angle and flange length are measured against the drawing, springback is compensated in the program, and the settings are locked for the balance of the run.
Works alongside
Also asked
What is the difference between air bending and coining?
Air bending leaves the material supported at two points and uses the punch depth to set the angle — it is fast and gentle on tooling. Coining forces the material fully into the die for a precise angle at higher tonnage. We use air bending for most work and coining where the angle must be exact.
Ready to start a job?
Send a drawing and we will come back with pricing and a lead time.