Sheet Metal
& Steel Fabrication

Services

Laser Cutting

Home/Services

Laser cutting gives a direct route from a drawing to a burr-free, dimensionally accurate steel part. A focused fibre beam follows the profile with minimal heat input, which means less distortion and cleaner edges than older thermal processes — important when parts must fit without grinding.

For the customer, laser cutting means two things. Geometries that were once expensive — curved slots, fine tabs, closely spaced holes — become routine, and repeat runs become genuinely repeatable because the same program cuts the same profile every time.

What the service covers

  • Profile cutting — brackets, plates, flanges and panels
  • Holes & cut-outs — slots, tabs and keyways in one pass
  • Fine features — small radii and close hole spacing
  • Nested batches — multiple parts from one sheet
  • Engraving — part numbers and fold lines marked on the surface

Specifications

Sheet sizeUp to 3000 × 1500mm
Mild steelTo 20mm
StainlessTo 12mm
AluminiumTo 8mm
Tolerance±0.2mm

Typical jobs

  • Brackets and plates
  • Panel cut-outs
  • Sprockets and profiles
  • Wear strips
  • Batched production parts

How the job is run

We nest parts to minimise waste and sequence cuts so fine features are cut before heavy profiles. First-off parts are measured, and the laser’s focus and speed are set for the material.

Checked before dispatch

A laser-cut edge should be square and free of dross. Edges are checked before folding or welding — correcting a profile is far cheaper at the bench than at assembly.

Common question

Can you cut aluminium?

Yes, to 8mm. Aluminium reflects more of the beam than steel, so speeds and gas settings differ — but the edge quality and tolerance are the same standard as steel.

What helps us quote faster

  • The drawing in DXF, DWG, STEP or PDF — or a dimensioned sketch
  • Material and thickness, or the part’s service conditions
  • Quantity and any tolerance or edge finish requirements
  • Delivery suburb and required date

Pairs well with

One more thing

Can you cut a part without a drawing?

In most cases, yes. Send a dimensioned sketch or clear photographs with overall sizes, and we will produce a cutting drawing for your approval before any material is cut.

Ready to start a job?

Send a drawing and we will come back with pricing and a lead time.

Request a Quote