Sheet Metal
& Steel Fabrication

Services

Site-Measured Metalwork

Home/Services

Buildings are never as square as the drawings. Site-measured metalwork closes that gap: we measure the actual opening, floor or fixing points before fabrication, so the steel fits the building instead of the building being forced to fit the steel.

The measurement visit is the cheapest safeguard in fabrication. An hour on site with a tape and a level prevents days of cutting, packing and reworking, and avoids disputes over responsibility.

What the visit covers

  • Site measurement — openings, floors and fixings recorded
  • Handrails & stairs — matched to the actual structure
  • Screens & infill panels — cut to the measured opening
  • Repairs — sections matched to existing steel
  • Installation — by the same crew that measured

Specifications

VisitSite measure before fabrication
RecordDimensions, levels and fixing types
FabricationTo the measured sizes, with allowances confirmed
InstallationOwn crew across NSW

Typical jobs

  • Stair handrails
  • Window and door screens
  • Structural repairs
  • Platform infill
  • Awning brackets

How we close the gap

We record the critical dimensions, note the fixing type, and fabricate with the allowances the site actually needs. The crew that measures also installs.

Trial-fitted first

Measurements are recorded on a sketch and checked back with the customer before fabrication. If a dimension looks unusual, we check it with the customer before fabrication.

Common question

How accurate is site measurement?

Where practical we work to ±5mm on openings, with allowances for uneven floors and walls. Tight-fit work is measured with the fixing method in mind from the start.

What to have ready

  • The address and access for a measurement visit
  • The existing structure the steel must match
  • Photos of the area if a visit is not yet possible
  • Any fixing restrictions we should know about

Also useful

One more thing

What happens if the site measure differs from the plan?

We fabricate to the measured dimensions, not the plan, and tell you where the difference lies before cutting. That is the whole point of measuring first.

Ready to start a job?

Send a drawing and we will come back with pricing and a lead time.

Request a Quote