Sheet Metal
& Steel Fabrication

Services

Reverse Engineering

Home/Services

Reverse engineering starts with a worn, broken or discontinued part and ends with a new one that fits. It is measurement, drawing and fabrication in one package — and it is how machines that are no longer supported keep working.

The discipline of reverse engineering is knowing what can be measured and what must be assumed. We measure the surviving geometry, compare against the mating part where possible, and draw the part as it was before it wore. The customer approves that drawing before any steel is cut.

What the service covers

  • Sample measurement — critical dimensions recorded
  • Drawing preparation — the part as it was before wear
  • Approval — you sign the drawing before we cut
  • Fabrication — laser, fold, weld and machine coordination
  • Fit check — trial against the assembly where possible

Specifications

InputWorn or broken sample, or photos with dimensions
OutputApproved drawing + fabricated part
MaterialMatched or upgraded to suit the duty
Lead timeTypically 3–5 working days from approval

Typical jobs

  • Discontinued machine parts
  • Worn brackets and plates
  • Damaged guards
  • Legacy equipment spares
  • Upgraded replacements in better material

How we read the wear

The wear pattern shows how the part was loaded: wear on one face means load on that face; a crack at a corner means stress concentration. We use the wear pattern to decide whether to upgrade the material or the detail instead of copying the failure.

Approved before cutting

The drawing is approved by the customer before fabrication. If the sample cannot be measured reliably, we say so and agree the assumptions first.

Common question

Can you improve a part that keeps failing?

Yes. If the wear pattern points to a weak detail, we will suggest a change — thicker section, better material, a radius instead of a sharp corner — and you decide.

What to bring

  • The worn or broken sample, if you have it
  • Photos with overall dimensions if the sample cannot travel
  • The mating part or assembly for comparison
  • Any known failure mode or desired improvement

Pairs with

Worth knowing

Who owns the drawing you produce?

The drawing is prepared for your approval and becomes the master for your part. It is supplied to you with the fabricated component.

Ready to start a job?

Send a drawing and we will come back with pricing and a lead time.

Request a Quote