Sheet Metal
& Steel Fabrication

Support

Frequently Asked Questions

Home/FAQ

01 · What files do you need for a quote?

DXF, DWG, STEP or a dimensioned PDF is ideal. If you only have a sketch or a worn sample, send clear photos with overall sizes and we can work from that. For folded parts, a flat pattern is not essential — we can develop it from the finished dimensions.

02 · Which materials do you work with?

Stainless steel (304 and 316), mild steel, galvanised steel and aluminium. Tell us the service conditions — indoor, coastal, food contact, load-bearing — and we will recommend a grade and finish that suits the application.

03 · What are typical lead times?

Most one-off parts are ready within three to five working days of drawing approval. Batch runs and structural work are scheduled and confirmed at quotation stage. If you need a part urgently, tell us the required date and we will confirm whether it is achievable before you commit.

04 · Do you take on single parts?

Yes. One-off replacement parts and prototypes are a regular part of the work, alongside small batch and repeat production runs. The minimum order is one part, priced fairly for the set-up involved.

05 · Can you work from a sample or a photograph?

Yes. For reverse-engineering work we can measure a worn or broken part and produce a drawing before cutting. Photographs help, but overall dimensions are essential — include a ruler or tape in the photo where possible.

06 · Can you install on site?

Yes. Guardrails, gates, awnings, frames and equipment supports can be installed by our own crew. Site access and fixing details are confirmed before fabrication, and any approvals required are the customer’s responsibility.

07 · What finish options are available?

Painted, polished and linished finishes are completed in-house. Powder coating and galvanising are completed through approved partners, with quality checked on return. Finish samples can be supplied before the run.

08 · Where are you located?

Our workshop is at 8/8 Priddle Street, Warwick Farm NSW 2170. Pickup is available by arrangement, and we deliver across New South Wales. See the contact page for details.

09 · How does payment work?

Payment terms are set out on the quotation or invoice. Work is typically scheduled once the order is accepted and any deposit stated on the quotation has been received.

10 · What tolerances can you hold?

Laser-cut profiles are held to ±0.2mm and programmed bends to ±0.5° as standard. Tighter tolerances are possible on request — tell us how the part fits and we will advise whether the tolerance is practical.

Still have a question?

Call 02 8607 8125 or send the drawing through the quote page.

Request a Quote