Two ways to put colour on steel, two different jobs. Powder coating gives a tough, even factory finish; wet paint is flexible, touch-up friendly and right for site work. The choice depends on where the part will be used and whether it will be modified on site.
Powder coating is a polyester layer cured in an oven. It is harder and more uniform than most wet paint, resists chipping and fading, and suits gates, balustrades, architectural screens and anything exterior that has to look good for years. Its weakness is repair: a deep scratch cannot be touched up invisibly, and the part may need re-coating.
Wet paint — especially two-pack systems — suits structural and site steel. It can be applied to parts that are too large or too installed for an oven, it is easy to touch up after transport or installation, and it can be colour-matched on site. Its weakness is that it depends on preparation and the applicator.

The decision usually comes down to three questions. Will the part be seen? Powder coat. Will it be welded, cut or scratched on site? Wet paint. Does it need to match an existing colour exactly? Both can, but powder coat colours are fixed by the coater while wet paint can be mixed to a sample.
Whichever finish is chosen, preparation decides the outcome. Spatter, rust and mill scale all show through a coating. We prepare the part for the finish we are applying — and when powder coating is required, we manage the process through our approved partner and inspect the result on return.
What it means for your next order
- Powder coat where the part is seen and permanent; wet paint where it will be worked on or touched up.
- For exterior steel, specify the coating system and the colour; preparation determines how long it lasts.
- For colour matching, a RAL number or a physical sample is more accurate than a photo.
Questions we ask before quoting
- Indoor or outdoor?
- Will it be scratched or welded on site?
- Does it need to match existing work?
Ready to start a job?
Send a drawing and we will come back with pricing and a lead time.