Sheet Metal
& Steel Fabrication

Projects

Residential Gate

Home/Site-measured steel gate

Industry: Residential · Scope: Steel gate, frame and posts · Location: Sydney

A homeowner wanted a steel gate across a sloping driveway — hung true, painted to match the fence, and built to survive the weather without sagging.

Gate frame on the workshop jig
Gate frame on the workshop jig

The challenge

The driveway fell 120mm across the opening, so a rectangular gate would never sit level. The existing posts were out of plumb, and the gate had to be light enough to swing by hand while staying stiff enough not to drop over time.

The solution

We measured the opening and the fall, then fabricated the gate with a raked bottom edge to follow the ground line. The frame was welded on a jig with the hinge positions set for the actual weight, and the gate was swung in the workshop before painting. Posts were set plumb and the gate hung and adjusted on site.

Installed gate following the driveway line
Installed gate following the driveway line

The result

The gate swings level, latches cleanly and follows the driveway line. The painted finish matches the fence, and the hinge detail allows adjustment if the ground settles.

Fall accommodated120mm
FinishColour-matched paint
SwingAdjusted on site
FabricationJigged and pre-swung

Key decisions that made it work

  • Raked the bottom edge to follow the 120mm fall, so the gate sits level with the ground.
  • Set the hinges for the actual weight, not the drawing estimate, and pre-swung the gate in the workshop.
  • Detailed adjustable hinges so the gate can be re-trued if the ground settles.

Planning a similar job?

  • Measure the opening and the fall before fabrication; most gate problems start at the hinges.
  • Colour-match the finish to the fence with a physical sample.
  • Ask for the gate to be pre-swung in the workshop.

Ready to start a job?

Send a drawing and we will come back with pricing and a lead time.

Request a Quote
All projects