A food manufacturer’s mixer failed when a stainless drive bracket cracked. The original part was discontinued, the machine was down, and every day of downtime was costing production.

The challenge
The broken bracket was the only sample, and the crack ran through a critical mounting face. The surviving geometry had to be measured carefully, the wear pattern understood, and a new part made from food-grade stainless in days, not weeks.
The solution
We measured the surviving faces, compared against the mating shaft housing, and produced a drawing showing the part as it was before failure. The customer approved the drawing the same day, and we laser-cut, folded and welded the replacement in 316 stainless, with the mounting face machined flat.

The result
The mixer was back in service four days after the part arrived at our door. The replacement is in service, and the customer now holds the approved drawing for any future reorder.
Key decisions that made it work
- Measured the surviving faces and compared against the mating housing, rather than assuming the broken edges were original.
- Produced a drawing for same-day approval, so the customer signed the part as it was before failure.
- Machined the mounting face flat after welding — the face the customer actually bolts to.
Planning a similar job?
- Keep the broken part; it answers questions photographs cannot.
- Bring the mating part if you can — it establishes dimensions the sample has lost.
- Tell us the downtime cost so we can confirm the fastest realistic route.
Ready to start a job?
Send a drawing and we will come back with pricing and a lead time.